Here are a few controls that you can take to guarantee basic safety in your house today. The objective is to avoid lethal and unwanted high voltage accidents and injuries. The ordinary do-it-yourself guy can easily do all of the repairs to these risky situations but there’s nothing to replace an experienced electrical technician. Here are some of the things you can do:

1. Outlets

Look for outlets that have plugs that are loose-fitting as these may overheat and cause a fire. Replace any wall plates that are broken or missing. Ensure that safety covers are placed on outlets that can be reached by kids.

2. Cords

Ensure that the cords are in excellent shape, not broken or scratched. Make absolutely sure they’re out of the areas of traffic. The cords on the wall and baseboard should never be stapled. Do not put cords under rugs, carpets, or any furniture.

3. Extension Cords

Inspect to see that there is no overloading. Furthermore, extension cords are only used temporarily. They aren’t designed as a permanent household fixture. Ensure that the cables have security locks to avoid shock risks for young kids and accidents such as mouth burns.

4. Plugs

Ensure that the plugs fit all outlets. Do not remove the third prong or the ground pin just to fit them to a two-prong outlet. Doing so could cause electrical shocks. Remember that you should never ever force plugs that don’t fit in an outlet. All plugs should securely fit to avoid overloading and damage.

5. GFCIs

GFCI stands for Ground Fault Circuit Interrupters and they’re designed to prevent electrocution. They must be used in all areas where there’s a possibility for electricity and water gets in contact. If the GFCI senses leakage, it will assume that there’s a ground fault. It will interrupt the power into your home to prevent injuries from electrical shocks. Always test this sensor to ensure that it is working properly at all times.

6. Light Bulbs

Check the light bulb’s wattage to ensure that they follow the right wattage for the fixture size. Replace all bulbs with a higher wattage than required. If you have problems determining the right wattage, check with the manufacturers of the light fixtures. Ensure that the bulbs are installed securely as there’s a tendency for loose bulbs to overheat.

7. Circuit Breakers and Fuses

Fuses and circuit breakers must follow the correct size and current rating. If you don’t know this detail, then hire an electrician to determine the right size. Remember to replace fuses of a similar size.

8. Don’t mix water with electricity

Never leave appliances plugged in, especially if there’s a chance of them getting wet. If ever plugged-in appliances fall into the water, don’t reach in and to pull it. Make sure that the power source is removed from the panel boards and unplug the appliances. If any appliances got wet, never use it until it’s been checked by technicians.

If you have any problems with your electricity, simply consult with St. Louis electricians so, you can get the quickest resolution to the problem.